Abst:The selection of threaded or compression brass fittings depends on the specific application and the type of connection required. Here is a brief explanation of each connection method:
Threaded Brass Fittings: Threaded fittings have male and female threads that screw together to create a secure connection. The correct connection method for threaded brass fittings involves the following steps:
Thread Preparation: Ensure that the threads on both the fitting and the pipe are clean and free from debr...
The selection of threaded or compression brass fittings depends on the specific application and the type of connection required. Here is a brief explanation of each connection method:
Threaded Brass Fittings: Threaded fittings have male and female threads that screw together to create a secure connection. The correct connection method for threaded brass fittings involves the following steps:
Thread Preparation: Ensure that the threads on both the fitting and the pipe are clean and free from debris or damage. Use a thread sealant or Teflon tape on the male threads to create a watertight seal.
Hand Tightening: Hand-tighten the fittings together until they are snug. Use a wrench or a pair of pliers to further tighten the fitting, ensuring a firm and leak-free connection. Be careful not to over-tighten, as this can damage the threads.
Check for Leaks: Once the fittings are connected, check for any leaks by running water through the system or applying a pressure test. If leaks are detected, make adjustments by tightening the fittings further or reapplying the thread sealant.
Compression Brass Fittings: Compression fittings create a watertight seal by compressing a ferrule or ring onto the pipe. The correct connection method for compression brass fittings involves the following steps:
Pipe Preparation:
Brass Fittings Factory Cut the pipe cleanly and ensure that the end is smooth and free from burrs or rough edges. Use a pipe deburring tool or sandpaper to remove any imperfections.
Ferrule Placement: Slide the compression nut and then the compression ferrule onto the pipe, making sure the smaller end of the ferrule faces towards the fitting.
Compression: Insert the pipe into the fitting until it seats fully. Hand-tighten the compression nut onto the fitting, ensuring it is snug. Then, use a wrench to tighten the nut another 1/4 to 1/2 turn, compressing the ferrule onto the pipe and creating a tight seal.
Check for Leaks: Once the fitting is connected, check for any leaks by running water through the system or applying a pressure test. If leaks are detected, make adjustments by tightening the compression nut further or replacing the ferrule if necessary.
